OURS Production40K100K160K 60W PZT-4 Multi-Frequency Ultrasonic Piezoelectric Oscillator Cleaning Oscillation

The mechanism of ultrasonic cleaning is to make use of the physical effects such as cavitation, radiation pressure and sound flow in the cleaning liquid. It can exfoliate the machinery produced by the dirt on the cleaning parts, and can also promote the chemical reaction between the cleaning liquid and the dirt, so as to achieve the purpose of cleaning the object. The frequency of the ultrasonic cleaning machine can be selected by 10~500 kHz according to the size and purpose of the cleaning material, generally more than 20~50 kHz. With the increase of the frequency of ultrasonic transducer, Langerhans oscillator, longitudinal oscillator and thickness oscillator can be used. In the miniaturization aspect, radial vibration and flexural vibration are also adopted. Ultrasonic cleaning has become more and more widely used in various industries, agriculture, household equipment, electronics, automobile, rubber, printing, aircraft, food, hospital and medical research.

The transducer uses different piezoelectric materials to explain that:
The black chip is P4 series, which is a medium power emitting material with dual transmitting and receiving characteristics.
With low dielectric loss and high mechanical quality factor, it is mainly used in ultrasonic cleaning, ultrasonic atomization and so on.
The Yellow chip is P8 series, which is a high-power emission material with high mechanical quality factor.
Good stability, very low dielectric loss, especially suitable for making high-power ultrasonic transducers. Widely used in
Ultrasonic welding, ultrasonic emulsification, ultrasonic polishing, ultrasonic cleaning and so on.

Main Features:

• High Q value.
• Large amplitude.
• High conversion frequency, low heat.
• Output is stable.
• Strict quality control.

 The ultrasonic vibrator should be placed in a dry place to prevent the ultrasonic vibrator from getting wet, which will affect the normal work. If the ultrasonic vibrator gets wet, put it in an oven and set it to dry at about 100 ℃ for 2 hours or use a hair dryer to dehumidify until the resistance is normal. The ultrasonic vibrator is degummed. After the ultrasonic vibrator is degummed, the ultrasonic power output is normal, but due to the vibrator and vibration The surface connection is not good. If you work for a long time, the vibrator will be burned out. Generally, the ultrasonic transducer degumming should be repaired or replaced by a professional ultrasonic manufacturer.
Maintenance of ultrasonic vibrator:
If it has not been used for more than a week, please cover it with a dust cover (plastic bag); except for the lubricating oil that has been received by the lifting screw before leaving the factory, all other parts do not need to be oiled; Periodically check whether the internal vibrator output line is worn; Dust, please wipe it with a clean cloth. Every six months, the dust inside the machine should be blown with dry compressed air. It is strictly forbidden to use various fluxes when cleaning the side plates and surfaces of the welding machine. Neutral detergent should be used and wipe gently. When the water filter reaches 13 water levels, please drain the water. Every month when the welding machine is used, the sliding part should be cleaned and re-coated with high-quality lubricating grease. Pay attention to the safety of the machine at any time.

OURS Production40K100K160K 60W PZT-4 Multi-Frequency Ultrasonic Piezoelectric Oscillator Cleaning Oscillation