Vibration Ultrasonic Cleaning Equipment Driver 3000W 20KHZ-40KHZ Optional Ultrasonic Cleaner Generator Reactor Power Source

With this development of modern industry, ultrasonic cleaning equipment requirements are more stringent, the need for more powerful and more flexible control of ultrasonic cleaning system. My company is the need to develop in order to meet these network ultrasonic cleaning system.

Network physical layer using RS485 communication interface, using MODBUS protocol layer protocol. In order to facilitate the realization of the network and the information needs of ultrasonic cleaning system.

 Main technical index:

Operating voltage:220V      10%

Working current: Please note that the equipment can not run over the rated current for a long time

Ambient temperature:0-45℃                   Relative humidity:40%-90%

working frequency:160KHz below

Power control range:0-100%              by manual 16 grade, automatic 32-level power adjustment

Machine overheating protection:65℃                Dimensions:H x W x L = 130 x 270 x 380

 Panel function description: 

1. display window: display work frequency, current size, power level, working condition and fault condition.(Start / stop: control ultrasonic start and stop, automatic check after long press 2 seconds.)

1. constant current / sweep frequency: set constant current value and switch frequency sweep status [factory mode confirm this entry to next item].

2. plus: time plus time (setting the display time "XX.XX").

3. time minus: time timed minus (set display "ON/OFF").

4. Power Plus: increase the output power (set the display current "XX.XA").

5. power subtraction: reduce output power (set the display frequency "FX.XX").

power switch: control the 220V voltage.

Note: in this note, "X" is shown in the content, and others are letters. Following same.