Cycle Rate 800W Ultrasonic Power Supply Automatic Searching Frequency Digital Ultrasonic Welding Generator

Ultrasonic welding converts a 50/60 Hz current into 15, 20, 30 or 40 KHz of electrical energy through an ultrasonic generator. The converted high frequency electrical energy is again converted by the transducer into a mechanical motion of the same frequency, and then the mechanical motion is transmitted to the welding head through a set of horn devices that can change the amplitude. The horn transfers the received vibrational energy to the joint of the workpiece to be welded, in which the vibrational energy is converted into thermal energy by friction to melt the plastic. Ultrasound can be used not only to weld hard thermoplastics, but also to fabrics and films.

Characteristics of ultrasonic generator:

1, the energy of the transducer is strong and stable
2, the use of automatic control system, overload protection device, accurate time to 1/100 seconds, stable quality.
3, excellent quality imported component assembly, perfect line control, ensure machine quality and performance stable.
4, adopt the upper die to adjust the four point balance, so that the mold adjustment is convenient and quick.
5, chrome plated alloy steel concentric straight column design, precision lever lifting rocker, small pitch, vertical vertical precision, to ensure the accuracy of workpiece welding.
6, divided design: the main electronic components are concentrated in the electronic box to avoid the possible damage to the circuit caused by the long-term use of the oil and water from the vibration and pneumatic components, and the heat dissipation is good and the mechanical life is prolonged.

 1.Add button[]

The add button is used to enter the menu and the lower level menu, setting the time of the time welding, the working frequency of the welding, the welding working current, the increase of the welding working power and the selection of other welding working parameters.

2.Clear button[RESET]

   Remove the record of the welded workpiece.

3.Reduce button[]

The reduction button is used to exit the parent menu, setting the time of the time welding, the working frequency of the welding, the welding working current, the decrease of the welding working power and the selection of other welding working parameters.

4.SCAN button[SCAN](program without this function)

5.Mode switch button [MODE]

The mode switch button is used to switch setting welding work parameters and save setting welding work parameters.

6.Test button [TEST]

   Test welding workpiece parameter setting effect.

7.LCD display window

The LCD display window is used to display the timing of the time welding, the working frequency of the welding, the working current of the welding, the working power of the welding and the setting of other welding working parameters.

Cycle Rate 800W Ultrasonic Power Supply Automatic Searching Frequency Digital Ultrasonic Welding Generator